NEC Display Wall Calibrator Guía de usuario descargar pdf (Pagina 66)

66 | NEC DISPLAY WALL CALIBRATOR - USER’S GUIDE

The IR Remote tab can be used to perform the equivalent operations as the physical IR Remote control using the

software and communicating using the LAN or RS232 connection to the display.

This is useful when it is not practical to use the actual IR Remote control with the display, or when it is necessary

to access controls by remote that are not available from within the software.

Select the display to control from the Apply To Display list. Click the buttons to send the IR Remote command to

the display. The display will respond as if it received a signal from the IR Remote control.

Sequences of commands can be created and sent to the display at once by clicking the Send Sequence button.

The IR Remote command code will appear in the Code Sequence list and can be manually edited. Each IR

Remote button is a single 2 hex digit code.

To prevent each IR Remote command codes from being sent to the display as each button is pressed, deselect

the Send Immediately checkbox.

Display Settings dialog - IR Remote tab

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 91 92

Sin comentarios

NEC Display Wall Calibrator Guía de usuario Pagina 66