NEC Express5800/R120f-1M Guía de instalación descargar pdf (Pagina 80)

3. Setting Up Windows Server 2012 R2

Express5800/R120f-1M, R120f-2M Installation Guide (Windows)

Chapter 1 Installing Windows

3.5

Setting Up Device Drivers

Install and set up device drivers provided for the standard configuration.

For details regarding the installation and setup of a driver for an optional device, refer to the manual supplied

with the optional device.

3.5.1

Installing the LAN drivers

(1) LAN drivers

If EXPRESSBUILDER is used for setup, the LAN driver will automatically be installed.

If the Windows standard installer is used for setup, install Starter Pack to install the LAN driver.

Important

• Teaming of network adapters by using BACS or PROSet is not supported.

• Wake On LAN (WOL) is supported by the standard network adapters only.

Note

• To change the LAN or BACS driver settings, log on to the system from a local

console using an administrator’s account. Remotely changing the settings by

using the operating system’s remote desktop feature is not supported.

• Be sure to select the Internet Protocol (TCP/IP) check box when specifying an

IP address.

(2) Optional LAN board

This server supports the following optional LAN boards.

Optional LAN board: N8104-149/150/151/152

The drivers for LAN boards are automatically installed using the OS plug-and-play function.

Note

Using an optional LAN board, perform procedure in Chapter 1 (3.5.2 Setting up

LAN drivers) for each optional LAN board.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 343 344

Sin comentarios

NEC Express5800/R120f-1M Guía de instalación Pagina 80