
5. Setting Up Windows Server 2008 R2
Express5800/R120f-1M, R120f-2M Installation Guide (Windows)
Chapter 1 Installing Windows
5.5
Setting Up Device Drivers
Install and set up device drivers provided for the standard configuration.
For details regarding the installation and setup of a driver for an optional device, refer to the manual supplied
with the optional device.
5.5.1
Installing the LAN drivers and BACS (teaming utility)
(1) LAN drivers and BACS
If EXPRESSBUILDER is used for setup, the LAN drivers and BACS will automatically be installed.
If the Windows standard installer is used for setup, install Starter Pack to install the LAN driver and BACS.
Important WOL is supported by the standard network adapters only.
Note
• To change the LAN driver and BACS settings, log on to the system from a local
console using an administrator’s account. Remotely changing the settings by
using the operating system’s remote desktop feature is not supported.
• Be sure to select the Internet Protocol (TCP/IP) check box when specifying an
IP address.
(2) Optional LAN board
This server supports the following optional LAN boards.
Optional LAN boards: N8104-145/149/150/151/152
The drivers for LAN boards are automatically installed using the OS plug-and-play function.
The LAN driver is not installed if N8104-145 is not installed at the time of installation of the OS by using
EXPRESSBUILDER or at installation of Starter Pack, or on a pre-installation model.
Perform the steps below to install the N8104-145 LAN driver manually.
1. Insert EXPRESSBUILDER DVD into the optical disk drive.
If Autorun Menu appears, close the menu.
Tips
EXPRESSBUILDER DVD is unnecessary if Starter Pack was installed from
Internal Flash Memory. Proceed to the next step.
2. Open Command Prompt, and execute install.bat in the following folder.
When using EXPRESSBUILDER DVD:
EXPRESSBUILDER DVD:\007\win\winnt\ws2008r2\lan
If Starter Pack was installed from Internal Flash Memory:
System Drive:\StartPKG\ws2008r2\lan
Comentarios a estos manuales