NEC Express5800/R120f-1M Guía de instalación descargar pdf (Pagina 27)

3. Setting Up Windows Server 2012 R2

Express5800/R120f-1M, R120f-2M Installation Guide (Windows)

Chapter 1 Installing Windows

Setup when mass memory is installed

If mass memory is installed in your system, the large size of paging file is required at installation. Thus,

the partition size for storing debug information (dump file) may not be secured.

If you fail to secure the dump file size, use Windows standard installer for setup, and allocate the

required file space to multiple disks by performing the following steps.

1. Set the system partition size to a size sufficient to install the OS and paging file.

2. Specify another disk as the destination to store the debug information (required dump file size) by

referring to Chapter 1 (7. Setup for Solving Problems).

If the hard disk drive does not have enough space to write the debug information, set the partition size

to a size sufficient to install the OS and paging file, and then add another hard disk drive for the dump

file.

Note

If the partition size for installing Windows is smaller than the recommended

size, expand the partition size or add another hard disk drive.

If sufficient space cannot be secured for the paging file, perform either of the following after setting up

using Windows Standard Installer is complete.

−

Specify a hard disk drive other than the system drive as the location to store the paging

file for collecting memory dump

Create a paging file of the installed memory size + 400 MB or more in a drive other than the

system drive.

The paging file that exists in the first drive (in the order of drive letter C, D, E, ...)

is used as the temporary memory dump location. Therefore, the size of the

paging file must be "installed memory size + 400 MB" or more. Paging files in

dynamic volumes are not used for dumping memory. The setting is applied after

restarting the system.

Example of correct setting

C: No paging file exists

D: Paging file whose size is "installed memory size + 400 MB" or more

→ The paging file in drive D can be used for collecting memory dump

because its size satisfies the requirement.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 343 344

Sin comentarios

NEC Express5800/R120f-1M Guía de instalación Pagina 27