NEC Express5800/320Lb Linux Guía de usuario descargar pdf (Pagina 171)

Installing and Using Utilities 5-45

Firmware Update

NEC Express5800/ft series can update firmware (including BIOS) if some hardware components

operate in the online state (in which the system continues the operation but the component trying to

update firmware or BIOS is stopped).

Updating firmware can be performed from the ft server utility.

To update the firmware of a component, the firmware image file of the firmware for update must

previously be stored in the managed server. On the firmware update screen, specify the path to the

firmware image file for update.

The table below shows the potential cases in which the firmware of a component is to be updated.

Firmware update

Component

Remote Local

CPU Module

–

When BIOS must be updated to new

one.

Executable in the following module

state:

• When the status LED 1 is red and the

status LED 2 is off

Only the status LED 1 illuminates red

when the module is in one of the

following states:

• Removed

• Broken or forced stop

• No fault found by diagnosis

(Firmware Update Complete)

To update the module under operation,

bring down the module before the

update.

Remote: Executable from remote management PC by using NEC ESMPRO Manager

Local: Executable on local server by using ft server utility

–: Not support

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 295 296

Sin comentarios

NEC Express5800/320Lb Linux Guía de usuario Pagina 171