search

NEC ND-70919 Manual de usuario Pagina 160

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 211
  • Tabla de contenidos
  • MARCADORES
    • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 159
CHAPTER 4 CIRCUIT CARD INFORMATION
PN-BRTA (BRT)
NEAX2000 IVS
2
ISDN System Manual
ND-70919 (E), Issue 1.0
Page 149
The figure in the SWITCH NAME column and the position in in the SETTING POSITION
column indicate the standard setting of the switch. When the switch is not set as shown by the
figure and , the setting of the switch varies with the system concerned.
NOTE 1: Set the groove on the switch to the desired position.
NOTE 2: When the power is on, flip the MB switch to ON (UP position) before plugging/
unplugging the circuit card.
SW1 (DIP SW)
1
For terminating the transmitting side
of channels B1 and B2 with 100
ohms
OFF
To remove the terminating resistor
on the transmitting side of channels
B1 and B2
2
For terminating the receiving side of
channels B1 and B2 with 100 ohms
OFF
To remove the terminating resistor
on the receiving side of channels B1
and B2
(Continued)
SWITCH NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION CHECK
1
2
ON
ON
ON
Vista de pagina 159
1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 210 211

Comentarios a estos manuales

Sin comentarios
  • Kettler Sengled ENERMAX TekNmotion ParagonBath
  • Orion Kits De Videovigilancia Antec Fuentes De Alimentación Pontiac No Dell Teléfonos móviles Pioneer Receptores AV
  • Acer P7215 Jvc MX-K10R Samsung WAM1500 Ariston AML 105 Enviro Focus
  • Hp Smart Array P830 Controller Manual de usuario Daewoo KQG-6C4R Manual de usuario Samsung EK-GN120 Manual de usuario Alpine IVE-W530 El manual del propietario Lorex CVC6950PK4B Ficha de datos