NEC Express5800/R110d-1E Guía de instalación descargar pdf (Pagina 12)

♦To change the settings of the SNMP Service

1 Click [SNMP Service] from the service list and then [Properties] in the [Action] menu.

The "SNMP Properties" dialog box appears.

2 Enter "public" or an arbitrary name in the [Community name] box of the [Traps] property sheet and click

[Add to list].

To change the community name of traps to be received from the default "*" in NEC ESMPRO Manager site,

enter the same name as the community name newly set in NEC ESMPRO Manager site.

To receive trap from NEC ESMPRO Agent at NEC ESMPRO Manager machine, both community names should

be the same.

3 Click [Add].

4 Click the [Add...] button in [Trap destinations]. After entering the IP address of the NEC ESMPRO

Manager machine of the send destination in the [Host name, IP or IPX address] box, click the [Add]

button.

If you specify the same IP address (or host name) specified on the trap destination also for the Manager Alert

(TCP/IO) setting, a warning message appears to indicate redundancy. With this configuration, the alert is

redundantly sent to NEC ESMPRO Manager of a specified IP address (or host name).

5 Open the [Security] property sheet and click the [Add] button [Accepted community names].

6 Set its authority to [READ CREATE] or [READ WRITE].

If you do not set the authority of [Accepted community names] as "READ CREATE" or "READ WRITE", you

cannot perform configuration or monitoring from NEC ESMPRO Manager.

7 Click Select [Accept SNMP packets from any host].

- Setup of receiving SNMP packets from specific communities only.

Change the name of the community receiving SNMP packets from the default "public" to any name.If

the community name is changed, the community of NEC ESMPRO Agent is changed and registered by

starting from [Control Panel]. To change the community to another and register it, use the [SNMP

Community] list box in the [General] tab.

To allow NEC ESMPRO Agent to receive SNMP packets sent from NEC ESMPRO Manager, set the

send community name in NEC ESMPRO Manager to be the same as that accepted by the SNMP

Service in NEC ESMPRO Agent.

- Setup of receiving SNMP packets from specific hosts only.

Select [Accept SNMP packets from these hosts], specify IP addresses of the hosts, IP addresses of the

servers to install NEC ESMPRO Agent, and the loop-back address (127.0.0.1).

8 Click [OK] Terminate the network setup.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Sin comentarios

NEC Express5800/R110d-1E Guía de instalación Pagina 12