NEC Express5800/120Bb-6 Guía de usuario Pagina 105

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 146
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 104
85
6. Connect the internal cable to the two connectors on the disk array controller. See the figure below.
If it is difficult to connect the cable, remove the disk array controller from the mezzanine card slot
(Type 2) and connect the cable to the disk array controller.
Notice
When connecting each connector at both ends of the internal cable, locate
the cable so that its lock pin faces upward. Then, insert the connector until
the cable is locked.
Route the cable as shown in the figure above.
To disconnect the cable, push the portion indicated by an arrow in the figure below:
Connector at server side
Connector at backplane
board side
Internal cable
Vista de pagina 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 145 146

Comentarios a estos manuales

Sin comentarios