
81
2. Installing the Disk Array Controller
This section describes how to install the disk array controller in the server, using N8400-029F/030F NEC
Express5800/120Bb-6 as an example.
The disk array controller does not support the PCI hot-plug feature. Before
installing or removing the disk array controller from the server, always remove
the server from the Blade Enclosure.
Some limitations may be imposed on the installation to the mezzanine card slot
depending on the type of the server. Before installation, check the limitations by
referring to the User‟s Guide of the server.
1. Remove the two screws securing the rear cover.
2. Slide the rear cover toward the rear of the server.
Comentarios a estos manuales