NEC Express5800/340Hb-R Guia de preparacion descargar pdf (Pagina 62)

4-14 Windows Setup

Step 3: Disable Boot Monitoring Function

Check whether the power is ON and make settings for properly performing setup for later on.

This equipment has a function to monitor the main unit at startup. (Enabled in the configuration at

shipment)

When reinstalling the operating system, this monitoring function needs to be disabled. Otherwise

the installation may not be done properly. Follow the steps in this section and make proper settings.

IMPORTANT: If you skip the settings described here, the system will be restarted

forcefully while Windows setup screen is shown and the setup will be unsuccessful; BIOS

may repeat Windows setup in an invalid manner. In this case, you will need to restart the

setup procedures from the beginning.

TIPS: For details of operations for BIOS Setup Utility and parameters, see the separate

volume of User’s Guide.

1. Turn on the display and the peripheral equipment connected to the NEC Express5800/ft

series.

CHECK: If the power cord is connected to a power controller like a UPS, make

sure that it is powered on.

TIPS: When the AC power of the NEC Express5800/ft series is turned on, after

the power is supplied, BMC is synchronized between the PCI modules. Upon the

completion of the BMC synchronization, the POWER LED of either PCI module

will be lit.

2. Remove the front bezel.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 149 150

Sin comentarios

NEC Express5800/340Hb-R Guia de preparacion Pagina 62