NEC Express5800/R110d-1E Guía de instalación descargar pdf (Pagina 11)

NEC ESMPRO Manager Ver.5 Installation Guide (Linux)

1.3 Functions

The NEC ESMPRO Manager has following functions:

 Remote console

The remote console function allows the operator to view the managed component’s display screen from

the remote console.

During POST (Power On Self Test) just after the power is turned ON, or while DOS is active, data can be

input into the managed component from the keyboard. The managed component’s BIOS setup and POST

monitoring can be enabled remotely by this function.

Even after Linux has been booted, the operator can perform various operations such as OS setting change

or application execution while viewing the managed component’s screen on the remote browser.

CHECK:

 After Windows or Linux starts up, login to the EXPRESSSCOPE Engine series, key input

and mouse operation are possible from remote KVM.

 Information collection

The information collection function allows the operator to collect information from the managed

component.

Component Status: Managed component’s STATUS lamp state and power state.

Version Information: Information about the versions of NEC DianaScope Agent or NEC ESMPRO

Agent Extension, operating system,

LAN driver, and System BIOS

BMC Configuration: BMC configuration information. You can also change the information.

Power Restore Delay: Interval from AC-ON to DC-ON that is also set using BIOS Setup utility on

the managed component.

IPMI Information: Hardware information, log information, and the current status of each sensor.

Power Management: Managed component’s power value. You can read it for specified period.

 Power control

The following power control is provided for the managed component:

Power ON

Power OFF

Power Cycle (turns power on after turning it off.)

Reset

DUMP Switch (The managed component performs the same operation as when the dump switch is

pressed.)

Sutdown OS

 Component Monitoring

The component monitoring function always monitors the managed component’s STATUS lamp state and

power state. When a failure occurs, the function notifies the operator of the failure.

If the managed component is a CPU blade, this function also monitors and notifies the operator of the slot

change.

The component monitoring function is supported only via LAN.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 42 43

Sin comentarios

NEC Express5800/R110d-1E Guía de instalación Pagina 11