NEC Express5800/320Lb Linux Guía de usuario descargar pdf (Pagina 60)

4-16 Linux Setup

The RAID menu will be displayed.

4. Enter “1” and then press Enter.

“Status (Raid)” (the disks’ current status of RAID) will be displayed.

(Display example of the RAID status)

[Status(Raid)]

-----------------------------------------------------------------------------------------------

name partition label status member

md0 /boot /boot DUPLEX (1)sda1 (4)sdd1

md1 /user /usr DUPLEX (1)sda5 (4)sdd5

md2 /home /home DUPLEX (1)sda10 (4)sdd10

md3 /var /var DUPLEX (1)sda6 (4)sdd6

md4 / / DUPLEX (1)sda8 (4)sdd8

md5 /tmp /tmp DUPLEX (1)sda9 (4)sdd9

md6 swap DUPLEX (1)sda7 (4)sdd7

-----------------------------------------------------------------------------------------------

“name” is the name of a software RAID device.

“partition” is a mount point or a swap. If this field is blank, RAID is configured but not

mounted as a file system.

“member” is the information of the member configuring RAID. The information will be

displayed in the following format for the number of members.

(Slot number) name

If the status is error, (F) is marked on the right. In such case, you need to correct RAID.

status indicates the status of RAID. The following are the descriptions of the status

messages.

DUPLEX : Normal status.

RESYNCING (X.X%) : Being synchronized. When completed, it becomes

DUPLEX.

RECOVERY (X.X%) : Being recovered. The members with “-” mark on the

member field have not been built yet.

SIMPLEX : Only one side of RAID is built. If two members are

displayed on the member field, the member with “-”

mark is on standby before RECOVERY status. If

only one member is displayed, recovery is required.

ERROR : ERROR status. The members of RAID do not exist.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 81 82

Sin comentarios

NEC Express5800/320Lb Linux Guía de usuario Pagina 60