NEC Express5800/320Lb Linux Guía de usuario descargar pdf (Pagina 51)

Linux Setup 4-7

AC inlet A (for Group2)

AC inlet B (for Group1)

Rack-mount model (Rear)

Connect the power cords to NEC Express5800/ft series in the following order:

(1) Connect the power cord to the AC inlet B (for Group1)

(2) Connect the power cord to the AC inlet A (for Group2)

(3) Confirm that the POWER switch of the PCI module for Group1 is illuminated.

(4) Make sure that the two BMC Status LEDs for PCI modules (for Group1/for Group2) are

turned off.

IMPORTANT: If the BMC Status LED is red and blinking, do not start installing

Linux for NEC Express5800/ft series. Otherwise the setup may not be performed

properly.

Preparation is now completed. Start the installation of Linux for NEC Express5800/ft series.

<When the AC power is on (The power cord is plugged to the wall outlet and the main unit’s

power is off)>

(1) Check the LED of the PCI module’s POWER switch.

• If the PCI module for Group1’s POWER switch is lit, the PCI module for Group1 is

primary. Preparations are complete. Start the installation of Linux for NEC

Express5800/ft series.

• If the PCI module for Group2’s POWER switch is lit, the PCI module for Group1 is

secondary. Continue to (2). Make PCI module for Group1 the primary module.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 81 82

Sin comentarios

NEC Express5800/320Lb Linux Guía de usuario Pagina 51