NEC Express5800/R120a-1 Manual de usuario descargar pdf (Pagina 82)

Checking Location of Physical Device

The locate function can be used when you want to k

in the RAID Viewer

comput

the ty

now the slot to which a specific Physical Device appearing

is inserted in the computer or enclosure. In actual, locate turns on the DISK lamp on the

er or enclosure in which the specified Physical Device is installed. (The DISK lamp blinks depending on

pes of the computer or enclosures.) Searching for the Physical Device with the DISK lamp being ON allows

th vice for which "check location" is executed on the RAID Viewer and raidcmd to be identified.

Th automatically is turned off in 3 minutes. Also, the RAID Controller may have the Turn off

function ac d of RAID Controller.

e Physical De

e DISK lamp

cording to the kin

RAID Viewer and raidcmd don't su

lamp. Therefore, you ca

pport the indication of the status (ON or OFF) of DISK

n't recognize the l en yo ON

the lamp of two or more Physical Devices ON the p of

nie ber of the Physical

Device which turned on a DISK lamp beca

ocation of the Physical Device wh u tu

lam

at same time. You should turn

Physical Device one by one. It is conve nt when you put down the num

use you can confirm the number of the Physical

Device when turn off the DISK lamp.

Pr edure of Checking Locatio e oc n of Physical Devic

L c t

o a e is executed for a Physical Device. The locate proc ure is described below.

ID Viewer

Use [Locate(Lamp)] in [Control] menu.

Step 1

Start the RAID Viewer. Click a Physical Device to

be located on the tree view, select [Locate (Lamp)] on the

pull-down menu of menu item [Control], and click [ON]. Then

the DISK lamp on the Physical Device goes on (or blinks

depending on the type of the computer). The DISK lamp

automatically is turned off in 3 minutes.

Step 2 In case of the RAID Controller with Turn off function, [OFF] of [Locate(Lamp)] in the [Control] menu

becomes enable. To turn off the DISK lamp, click a Physical Device to be located on the Tree View, select [Locate

(Lamp)] on the pull-down menu of menu item [Control] and click [OFF].

raidcmd

Use "slotlamp" command.

Step 1

To turn on the DISK lamp for locate,

execute "slotlamp" command with the -sw option set

to "on" using the following parameters.

 Number of the RAID Controller containing the Physical

Device for which its location is checked

 Number of the Physical Device for which its location is checked

Step 2 To turn off the lighting DISK lamp, execute "slotlamp" command with the -sw option set to "off".

> raidcmd slotlamp -c=1 -p=3 -sw=on

> raidcmd slotlamp -c=1 -p=3 -sw=off

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 117 118

Comentarios a estos manuales

Sin comentarios

NEC Express5800/R120a-1 Manual de usuario Pagina 82

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas operativos NEC Express5800/R120a-1