NEC Express5800/R120a-1 Manual de usuario descargar pdf (Pagina 72)

Checking Logical Drive Consistency

The Consistency Check function checks the consistency bet

parity. The Universal RAID Utility can start or stop Consisten

ween the data in the data area of a Logical Drive and the

cy Check and change the priority in which Consistency

Check is executed.

The Co

Execu the RAID Controller does not support Patrol Read. If the Universal RAID

Utility is installed, routine execution of the Consistency Check is set for RAID Controllers not supporting Patrol Read.

nsistency Check is effective next to Patrol Read to find failures including Physical Device media errors early.

te Consistency Check periodically if

Starting or stopping the Consistency Check is enabled both in the Standard Mode and

Advanced Mode. The function of changing the priority at which the Consistency Check is

executed is available only in the Advanced Mode.

Exe ing Consistency Check Manually cut

Consistency Check is executed in Logical Drives. The procedure of starting Consistency Check is described

below.

The Consistency Check can be exec

The Cons

uted only for Logical Drives with [Status] being [Online].

istency Check cannot be executed for Logical Drives with RAID Level being RAID 0.

RAID Viewer

Use [Consistency Check] in [Control] menu.

k a Logical Drive on

click [Consistency Check] on the pull-down menu of menu

stency Check is started, the

rogress of the Consistency Check appears on the

peration View. At the completion of the

onsistency Check, [Status] on the Operation View is

hanged to [Completed].

Step 1

Start the RAID Viewer. Clic the Tree View. Then

item [Control].

Step 2 After Consi

raidcmd

Use "cc" command.

Step 1

Execute "cc" command with -op option

and the following parameters.

 Number of the RAID Controller containing the Logical

Drive for which Consistency Check is executed

 Number of the Logical Drive for which Consistency

Check is executed

Step 2 After the Consistency Check is started, the raidcmd terminates normally. Check the execution status of the

Consistency Check by using "oplist" command.

> raidcmd cc -c=1 -l=2 -op=start

> raidcmd oplist

RAID Controller #1

Logical Drive #2 : Consistency Check (30%)

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 117 118

Comentarios a estos manuales

Sin comentarios

NEC Express5800/R120a-1 Manual de usuario Pagina 72

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas operativos NEC Express5800/R120a-1