Nec Network Controller uPD98502 Manual de usuario Pagina 557

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 595
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 556
APPENDIX A MIPS III INSTRUCTION SET DETAILS
Preliminary Users Manual S15543EJ1V0UM
557
STANDBY
Standby
STANDBY
0
00 0 0 000 0000 0000 0000
COP0
0 1 0 0 0 0
STANDBY
1 0 0 0 0 1
31 26 25 6 5 0
6196
CO
1
1
24
Format:
STANDBY
Description:
STANDBY instruction starts mode transition from Fullspeed mode to Standby mode.
When the STANDBY instruction finishes the WB stage, this processor wait by the SysAD bus is idle state, after
then the internal clocks will shut down, thus freezing the pipeline. The PLL, Timer/Interrupt clocks and the internal
bus clocks (TClock and MasterOut) will continue to run.
Once this processor is in Standby mode, any interrupt, including the internally generated timer interrupt, NMI, Soft
Reset, and Cold Reset will cause this processor to exit Standby mode and to enter Fullspeed mode.
Operation:
32, 64 T:
T+1: Standby operation ()
Exceptions:
Coprocessor unusable exception
Remark Refer to Section 2.7.3.1 Power modes for details about the operation of the peripheral units at mode
transition.
Vista de pagina 556
1 2 ... 552 553 554 555 556 557 558 559 560 561 562 ... 594 595

Comentarios a estos manuales

Sin comentarios