NEC Express5800/1080Rf Guía de instalación Pagina 5

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 28
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 4
5
6. Input
"fs0:after Shell>, press <Enter>
Shell>fs0:
Command prompt will change to fs0:
7. Input setupldr after fs0:>, press <Enter>
fs0:>setupldr
When a SCSI/RAID adapter needs a driver other than OS standard driver, Please use the driver diskette
appended to the adapter, or the driver diskette which copied the driver files of EXPRESSBUILDER inclusion,
and execute OS installation in the following procedures.
For details, refer to the document appended to the adapter, or included on EXPRESSBUILDER.
(1) Press <F6> when the following message appears on the screen.
"Press F6 if you need to install..."
(2) Press <S> to specify an additional device when the following message appears on the screen.
(3) Insert the driver diskette and press <Enter> when the following message appears on the
screen.
(4) Select the appropriate driver from the list by arrow key. Press <Enter> to proceed.
(5) Press <S> when the following message appears on the screen. And advance the OS
installation according to message of the screen.
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage devices(s):
:
:
Please insert the disk labeled
Manufacturer-supplied hardware support disk
into Drive A:
* Press ENTER when ready.
The driver you provided seems to be older than the Windows
default driver.
:
:
S=Use the driver on flo
ppy
ENTER=Use the default Windows drive
r
Vista de pagina 4
1 2 3 4 5 6 7 8 9 10 ... 27 28

Comentarios a estos manuales

Sin comentarios