NEC Express5800/R110f-1E Guía de instalación descargar pdf (Pagina 59)

1.4 BMC Configuration

♦ BMC Configuration tool

Among BMC configuration information tools there are some tools which cannot be

ESMPRO Manager.

 NEC MWA Agent cannot be used.

 If NEC MWA is stored in E

used to setup NEC

XPRESSBUILDER DVD-ROM, [A setup of a system management] stored in

PRESSBUILDER DVD-ROM cannot be used.

A is stored in the same

♦ In case of exchange of PC for Management

If a PC for Management as an alert receiver has been exchanged, register the managed server is BMC

anagement remains unchanged.

HCP)"

s the function "Obtain an IP

of NEC ESMPRO Manager modules supports the setting of the function.

the same EX

 The Console-less function of EXPRESSBUILDER cannot be used when NEC MW

EXPRESSBUILDER DVD-ROM.

configuration information again even when IP address of PC for M

Otherwise, BMC may fail to recognize the alert receiver.

♦ Function "Obtain an IP Address automatically (D

The managed server included BMC that uses a Management LAN port support

Address automatically (DHCP)".

1. Following version

Managed server DianaScope

DianaScope Manager Ver.1.07.01 or later

DianaScope Agent Ver.2.03.05 or later

The managed server that integrates

EXPRESSSCOPE Engine series. DianaScope

Manager Ver.1.07.01 or later

DianaScope Configuration Ver.1.02 or later

DianaScope Manager Ver.1.11.00 or later

DianaScope Agent Ver.2.06.00 or later

The managed server installed Advanced

Remote Management Card.

DianaScope Configuration Ver.1.02 or later

When you use the module that does not support the setting of the function "Obtain an IP Address

automatically (DHCP)" for the managed server that supports the function, note followings :

- If DianaScope Agent does not support the setting of the function, DianaScope Agent always set

[disable] for the function when it registers BMC configuration. DianaScope Agent also set [disable]

when it writes BMC configuration information file.

- If DianaScope Configuration does not support the setting of the function, DianaScope Configuration

always set [disable] for the function when it writes BMC configuration information file.

- If [System Management] tool on EXPRESSBUILDER does not support the setting of the function, the

tool always set [disable] for the function when it registers BMC configuration. The tool also set [disable]

when it writes BMC configuration information file.

- If remote console feature of EXPRESSBUILDER does not support the setting of the function, the tool

always set "disable" for the function when it registers BMC configuration.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 69 70

Comentarios a estos manuales

Sin comentarios

NEC Express5800/R110f-1E Guía de instalación Pagina 59

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores NEC Express5800/R110f-1E