NEC Express5800/R110f-1E Guía de instalación descargar pdf (Pagina 47)

aged server is power

cannot be keyed in from the remote console or the keyed data display may be

 Remote Console is realized by using SOL function of IPMI conformity and the Serial Redirection function

o on) or the software

not control.

Refer to the document of each firmware or software for the details.

nsole via LAN, set

the item "Console Redirection" to "Disable" on BIOS Setup Utility screen, reboot the system, and then boot



If you set the value on the managed server which does not support power management, you cannot put

ach value, it is accepted as "unsetting".

ap value.

ering the frequency of CPU

When CPU / Memory Throttling value reaches 100%, the electric power value does not fall any more.

♦ In case of key-in failure on the remote console

 During DOS boot or access to the removable media immediately after the man

switch is turned ON, data

delayed.

of BIOS.

Data cannot be keyed in from the remote console when the firmware (BIOS and s

requires the key code that VT100 terminal emulator (the hyper-terminal and so on) can

♦ RAID EzAssist Configuration Utility

To operate RAID EzAssist for a SOL-incompatible managed server from CUI remote co

RAID EzAssist Configuration Utility.

♦ Power management

back the val

ue to "unsetting". Set "zero" to e

 The electric power value might not necessarily reach even the value of Power C

The electric power control lowers the power consumption of the system by low

/ Memory.

Note

For more detail about Power Monitoring and Power Control Function, reference the following site.

http://www.58support.nec.co.jp/global/download/index.html

[Others] - [Technology paper]

♦ CPU blade

When "Check Connection" of "C

auto registration

PU blade auto registration" was failed. You can execute "Check

PU blade auto registration"

registration"), NEC ESMPRO

be able to connect CPU blade because old information remains in ARP table on PC for

gement. Wait for a few minutes and try "Check Connection".

Connection" on "Server Properties" - "Connection Setting".

If a specified IP address is set from a CPU blade to another CPU blade during "C

process (ex. when you replace CPU blade and execute "CPU blade auto

Manager may not

Mana

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 69 70

Comentarios a estos manuales

Sin comentarios

NEC Express5800/R110f-1E Guía de instalación Pagina 47

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores NEC Express5800/R110f-1E