NEC Express5800/320La Guía de configuración descargar pdf (Pagina 20)

2-12 Configuring Linux

The following are determined:

<SCSI path> = d<DOMAIN No.>H<HOST No.>c<CHANNEL

No.>t<TARGET No.>l<LUN>

The tuple and path first displayed for a device, correspond to the primary path

used to access the device.

NOTE: If an extension SCSI board is mounted in a PCI slot, topology setting is

necessary.

To confirm the software RAID, execute [Status(Raid)].

A RAID status display sample is shown below.

[Status(Raid)]

-------------------------------------------------------------

name partition label status member

md0 /boot /boot DUPLEX (1)sda1 (4)sdd1

md1 /usr /usr DUPLEX (1)sda5 (4)sdd5

md2 /home /home DUPLEX (1)sda10 (4)sdd10

md3 /var /var DUPLEX (1)sda6 (4)sdd6

md4 / / DUPLEX (1)sda8 (4)sdd8

md5 /tmp /tmp DUPLEX (1)sda9 (4)sdd9

md6 swap /tmp DUPLEX (1)sda7 (4)sdd7

-------------------------------------------------------------

name: Software RAID device name

partition: Mount point or swap. If neither mount point nor swap is displayed,

the RAID is configured, but it is not mounted as a file system.

member: Information of the members making up the RAID. Information in the

following format is displayed for each member:

(slot-number) name

If a member is in error state, the (F) mark is shown to right of the member. In

this case, the RAID needs to be repaired.

status: Status information as shown below.

DUPLEX:Normal state

RESYNCING(X.X%): Synchronization in progress. DUPLEX is displayed

when synchronization is completed.

RECOVERY(X.X%): Recovery in progress. A member for which "-" is

displayed in Column "member" is not installed yet.

SIMPLEX: RAID installed in only one system. If two members are displayed

in the column "member," the member with "-" displayed is in standby state

before the RECOVERY state. If only one member is displayed, the RAID needs

to be repaired.

ERROR: No RAID members exist.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 101 102

Sin comentarios

NEC Express5800/320La Guía de configuración Pagina 20