NEC Express5800/R110f-1E Guía de instalación descargar pdf (Pagina 17)

9. Click Select [Accept SNMP packets from any host].

- Setup of receiving SNMP packets from specific communities only.

Change the name of the community receiving SNMP packets from the default "public" to any

name.If the community name is changed, the community of NEC ESMPRO Agent is

changed and registered by starting from [Control Panel]. To change the community to

another and register it, use [SNMP Community] list box in [General] tab.

To allow NEC ESMPRO Agent to receive SNMP packets sent from NEC ESMPRO Manager,

set the send community name in NEC ESMPRO Manager to be the same as that accepted

by SNMP Service in NEC ESMPRO Agent.

- Setup of receiving SNMP packets from specific hosts only.

Select [Accept SNMP packets from these hosts], specify IP addresses of the hosts, IP

addresses of the servers to install NEC ESMPRO Agent, and the loop-back address

(127.0.0.1).

10. Click [OK] Terminate the network setup.

Important - Some software products provided by other vendors can change SNMP Service

configuration. If install NEC ESMPRO Agent on the system under the condition

where these types of software are already installed, NEC ESMPRO Agent

service cannot work properly.

In such a case, delete SNMP Service once and then install the service again.

Afterward, reinstall NEC ESMPRO Agent and the software products provided by

other vendors.

- If do change the setting of SNMP Service while NEC ESMPRO Agent is running,

restart ESMDiskArray Service.

1.2.5

Monitoring RAID System

RAID System Management Utility is required to monitor RAID System.

If RAID System Management Utility is not installed, Install it with reference to the manual.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 46 47

Sin comentarios

NEC Express5800/R110f-1E Guía de instalación Pagina 17