NEC Express5800/320Ma Guía de instalación descargar pdf (Pagina 63)

The Post-IPL Procedure

Installing Express5800/320Ma System Software 6-9

16. A few minutes may pass before the system restarts and the post-IPL procedure

starts.

The Post-IPL Procedure

Perform the post-IPL procedure if Windows and Express5800/320Ma were preinstalled

on your system, or if you have just performed the IPL procedure.

Checklist: Performing the Post-IPL Procedure

❏ If you have not already done so, complete the Mini-Setup Worksheet. See

“Mini-Setup Worksheet” on page 6-3.

❏ Respond to Mini-Setup prompts. See “Responding to Mini-Setup Prompts” on

page 6-9.

❏ Complete the post-IPL procedure. See “Completing the Post-IPL Procedure” on

page 6-10.

NOTE

Before proceeding, check for the latest information about

your system and Express5800/320Ma in the Release

Notes: Express5800/320Ma on the NEC ExpressBuilder

CD (2 of 2) shipped with your system.

Responding to Mini-Setup Prompts

1. If you have just performed the IPL procedure, go to step 2. Otherwise:

a. Insert the disk that contains the boot partition in the following location:

– In a rack-mountable system, in the bottom-most slot in the top enclosure

– In a pedestal system, in the enclosure on the left, in its right-most slot

b. Turn on the system, if you have not already done so. See “Performing the IPL

Procedure” on page 6-6.

2. If the Welcome to the Windows Setup Wizard starts, respond to the Mini-Setup

prompts. If prompted by Mini-Setup, enter the license key again. (You are not

prompted for the license key if Windows was installed by the manufacturer.) Use

the information you provided in Ta ble 6 - 1 to respond to these prompts.

When Mini-Setup is finished, the system reboots.

NOTE

If your system contains VTMs, the mouse and keyboard

may appear unresponsive at some point after the system

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 75 76

Sin comentarios

NEC Express5800/320Ma Guía de instalación Pagina 63