NEC Express5800/320Ma Guía de instalación descargar pdf (Pagina 38)

Connecting the System to Ethernet Networks

4-4 Express5800/320Ma: System Installation Guide

2. Connect the USB cable from the keyboard to one of the system’s USB ports. The

system’s USB ports are interchangeable. Item 3 in Figure 4-1 and item 5 in

Figure 4-2 shows the USB ports on the system.

3. Connect the 15 pin D-sub connector on the VGA cable from the monitor to the

system’s VGA port. Item 4 in Figure 4-1 and item 6 in Figure 4-2 shows the VGA

ports on the system.

4. Connect the VGA cable to the monitor.

Connecting the System to Ethernet Networks

1. Connect the ports for the embedded Ethernet controllers to the network. Provide

an unshielded twisted pair (UTP) cable with RJ-45 connectors for each of the four

system Ethernet ports you plan to use. Connect one end of each cable to a network

port on the system and the other end to an Ethernet wall jack or switch. Item 3 in

Figure 4-1 and item 5 in Figure 4-2 shows the USB ports on the systems.

2. Connect the VTMs, if present, to a maintenance or other network. You need two

UTP cables with RJ-45 connectors. Connect one end of each cable to a VTM

network port. Attach the other end of each cable to an Ethernet wall jack or a

switch. Item 8 in Figure 4-1 and item 9 in Figure 4-2 shows the VTM ports on the

system.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 75 76

Sin comentarios

NEC Express5800/320Ma Guía de instalación Pagina 38