NEC Express5800/R120e-1M Guía de instalación descargar pdf (Pagina 22)

3. Setting Up Windows Server 2012

Express5800/R120e-1M, R120e-2M Installation Guide (Windows)

Chapter 1 Installing Windows

Setup when installing with a large amount of memory

When your system installed a large amount of memory, the large paging file is required at

installation and the dump file for debugging information may not be created.

If you fail to create the dump file, use Windows Standard Installer for setup, and allocate the

required file space to multiple disks by the following steps.

1. Set the system partition size to a size sufficient to install the OS and paging file.

2. Specify another disk as destination to save the debug information by referring to Chapter 1

(6. Setup for Solving Problems).

If the hard disk drive does not have enough space to save the debug information, set the partition

size to a size sufficient to install the OS and paging file, and then add another hard disk drive for

the dump file.

If sufficient space cannot be allocated for the paging file, perform either of the following after the

installation using Windows Standard Installer is complete.

― Specify a hard disk drive other than the system drive as the location to store the

paging file for collecting memory dump

Create a paging file of the installed memory size + 400 MB or more in a drive other than the

system drive.

Note

If the partition size for installing Windows is smaller than the recommended

size, expand the partition size or add another hard disk drive.

The size of the paging file must be "installed memory size + 400 MB" or more.

Paging files in dynamic volumes are not used for dumping memory. The setting is

applied after restarting the system.

Example of correct setting

C: No paging file exists

D: Paging file whose size is "installed memory size + 400 MB" or more

→ The paging file in drive D can be used for collecting memory dump

because its size satisfies the requirement.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 266 267

Sin comentarios

NEC Express5800/R120e-1M Guía de instalación Pagina 22