NEC Express5800/R120e-1M Guía de instalación descargar pdf (Pagina 150)

4. Setting Up Windows Server 2008 R2

Express5800/R120e-1M, R120e-2M Installation Guide (Windows)

150

Chapter 1 Installing Windows

(2) Setting up team

Important

Possible combinations of network adapters that compose the team are as

follows.

When the number of adapters that composes the team is up to four:

- Between N8104-145 adapters.

1. Open the Device Manager.

2. Open Network adapters → [Intel(R) xxx] properties.

3. Click Teaming tab and check the Team this adapter with other adapters check box.

Click New Team.

4. Fill the name of the team in Specify a name for the team and click Next.

5. Include the adapter to the team and click Next.

6. Select a team mode, and then click Next.

7. Click Finish.

8. Click TEAM: "Team name" from Device manager → Network adapters to modify the team.

Click Settings tab and click Modify Team button.

9. Refer to the following procedure to set the team member adapter priority status.

Note

Adapter priority config can be confirmed by the following procedure:

1. Click [TEAM: "Team name"] from [Device manager] → [Network adapters].

2. Click [Settings] and confirm Adapters in team list.

10. Click Test Switch → Run test to confirm the adapter team is properly setup.

11. Confirm the result in [Test results].

12. Restart the system.

(3) Procedure for deleting team

1. Open the Device Manager.

2. Click Network adapters, and open [TEAM: "Team name"] properties.

3. Click Setting tab.

4. Click Remove Team button.

5. Click Yes to the message.

6. Confirm [TEAM: "Team name"] adapter is not existing in [Network adapters] tree and restart the system.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 266 267

Sin comentarios

NEC Express5800/R120e-1M Guía de instalación Pagina 150