NEC Express5800/S110R-1 Guía de usuario Pagina 26
- Pagina / 134
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
2-10
Series3800/S110R-1 (5015M-UR/5015M-U/5015M-NTR/5015M-NT) User's Manual
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the SATA drives
and SATA backplane have been properly installed and all connections have been
made.
1. Accessing the drive bays
All drives are accessable from the front of the server. For servicing the DVD-
ROM and fl oppy drives, you will need to remove the top chassis cover. The SATA
disk drives can be installed and removed from the front of the chassis without
removing the top chassis cover.
2. DVD-ROM and fl oppy disk drives
A slim DVD-ROM and fl oppy drive should be preinstalled in your server. Refer
to Chapter 6 if you need to reinstall a DVD-ROM and/or fl oppy disk drive to the
system.
3. Check the SATA disk drives
Depending upon your system's confi guration, your system may have one or
more drives already installed. If you need to install SATA drives, please refer to
Chapter 6.
4. Check the airfl ow
Airfl ow is provided by three sets of 4-cm fans (each set of fans consists of two
fans that are mounted back to back). The system component layout was care-
fully designed to direct suffi cient cooling airfl ow to the components that generate
the most heat. Note that all power and data cables have been routed in such a
way that they do not block the airfl ow generated by the fans.
5. Supplying power to the system
The last thing you must do is to provide input power to the system. Plug the
power cords from the power supply modules into a high-quality power strip that
offers protection from electrical noise and power surges. It is recommended that
you use an uninterruptible power supply (UPS) source.
- Series3800/S110R-1 1
- Manual Revision 1.0d 2
- Release Date: April 15, 2008 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 4: System Safety 7
- Chapter 7: BIOS 8
- Appendices: 9
- User's Manual 10
- Introduction 11
- Chapter 1 11
- 1-2 Serverboard Features 12
- 1-3 Server Chassis Features 13
- Chapter 1: Introduction 15
- System Block Diagram 15
- 1-4 Notes 16
- Chapter 2 17
- Choosing a Setup Location 18
- Rack Precautions 18
- Server Precautions 18
- Rack Mounting Considerations 19
- Installing the Inner Rails 20
- Installing the Outer Rails 21
- Chapter 3 27
- 27
- System Interface 27
- 3-3 Control Panel LEDs 28
- 3-4 SATA Drive Carrier LEDs 29
- Chapter 4 31
- System Safety 31
- 4-3 ESD Precautions 33
- 4-4 Operating Precautions 34
- Chapter 5 35
- Advanced Serverboard Setup 35
- Installing the Processor 36
- Installing the Heatsink 38
- Removing the Heatsink 38
- 5-3 Connecting Cables 39
- Connecting the Control Panel 40
- 5-4 I/O Ports 41
- 5-5 Installing Memory 41
- 5-6 Adding PCI Cards 43
- 5-7 Serverboard Details 44
- PDSMU Quick Reference 45
- 5-8 Connector Defi nitions 46
- NIC1 LED 47
- NIC2 LED 47
- Universal Information LED 47
- Fan Headers 49
- Serial Ports 49
- Universal Serial Bus 49
- Headers 49
- LAN1/2 (Ethernet Ports) 52
- Power LED 52
- 5-9 Jumper Settings 53
- 5-10 Onboard Indicators 55
- Floppy Connector 56
- IDE Connector 57
- SATA Ports 57
- Precautions 59
- 6-2 Control Panel 60
- System Fan Failure 61
- Replacing System Fans 61
- Removing the Front Bezel 62
- Accessing the Drive Bays 63
- SATA Drive Installation 64
- 5015M-UR/5015M-NTR 67
- Power Supply Failure 67
- 5015M-U/5015M-NT 68
- User's Manual 70
- 7-1 Introduction 71
- 7-2 Running Setup 72
- 7-3 Main BIOS Setup 72
- Main BIOS Setup Menu 73
- Main Setup Features 73
- 7-4 Advanced Setup 76
- XHardware Monitor Logic 85
- 7-5 Security 86
- 7-6 Boot 87
- 7-7 Exit 88
- Appendix A 89
- BIOS POST Messages 89
- Appendix B 95
- BIOS POST Codes 95
- Appendix B: BIOS POST Codes 97
- Appendix C 101
- RAID Confi gurations 102
- Intel Matrix Storage 102
- Creating a RAID 0 Volume 104
- Creating a RAID 1 Volume 105
- Deleting a RAID Volume 108
- Appendix D 111
- Managing Arrays 114
- Confi guring Disk Drives 115
- Creating Arrays 118
- Rebuilding Arrays 124
- Using the Disk Utilities 126
- Appendix E 131
- System Specifi cations 131
- Operating Environment 133
- Regulatory Compliance 133
© 2020, manymanuals.es. Todos los derechos reservados | 0.041 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales