NEC Express5800/R120f-1M Guía de configuración Pagina 21

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 56
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 20
Server Configuration Utility User's Guide
21
Item Description Default Value
Access Limitation Access Limitation setting *12
Access Limitation
Type
Select the Access Limitation Type.
Allow All
: Access to BMC is not limited.
Allow Address
: Set the IP Address that is allowed to access BMC.
Deny Address
: Set the IP Address that is limited to access BMC.
Allow All
IP Address Set the IP Address to allow or deny to access with the
management LAN. *8 *9
Blank
*1: It is possible to set when the system supports change.
*2: If you modify this setting, "Reset BMC" is necessary on some systems. When set to "Shared BMC LAN",
the management LAN port is disabled. When set to "Shared BMC LAN", the network performance may be
reduced because the data of both LANs must be transmitted or received.
*3: When the Subnet Mask is wrong setting, error message, such as "Failed to apply configuration.", is
displayed.
*4: It is possible to set when DHCP is "Disable".
*5: It is possible to set when DHCP is "Enable".
*6: The length of Host Name must be less than 64 characters. Host Name will be truncated to 63 characters,
if you input over 63 characters.
*7: Host Name and Domain Name should be within total of 255 characters.
*8: The range of IP address to "Allow" or "Deny" access is delimited by ",(comma)". With regard to the
setting of “Deny” access, "*(asterisk)" can be described as a wild-card. (ex:
192.168.1.*,192.168.2.1,192.168.2.254)
*9: It is possible to set when Access Limitation Type is "Allowed Address" or "Denied Address". The length
must be less than 255 characters.
*10: The Blade Server does not support this item.
*11: This item is valid only when IPv6 is "Enable".
*12: It is displayed when IPv6 Address Assignment Mode is "Dynamic".
*13: It is possible to set when IPv6 Address Assignment Mode is "Static".
Vista de pagina 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Comentarios a estos manuales

Sin comentarios