Nec MultiSync LCD2335WXM Manual de usuario descargar pdf (Pagina 10)

Connecting to a Antenna / Cable

Make sure that the power switch of the LCD MONITOR is turned off and that the unit is disconnected from the AC power source.

Precautions when connecting the antenna

z

Use a coaxial cable which is free from interference. Avoid using a parallel flat wire as interference may occur, causing the reception to become unstable and

noise to appear on the screen.

z

Avoid using an indoor antenna as this may be affected by interference and poor reception.

z

Keep the power cord as far away from the antenna wire as possible.

z

Auto Tuning please refer to page 24

VHF(300-Ohm) antenna / UHF antenna

When using a 300-ohm twin lead from an outdoor antenna, connect the VHF or UHF antenna leads to the screws of the VHF or UHF adapter. Plug

the 300-ohm to 75-ohm adapter into the antenna on the LCD MONITOR.

When both VHF and UHF antennas are combined

Attach an optional antenna cable signal combiner to the LCD MONITOR antenna terminal, and connect the cables to the antenna mixer. Consult your

local electronics retailer about available signal combiners.

Reconnect the unit to the AX power source and turn on the power.

Using the Remote Control or User Controls, select the "CHANNEL SETTING MENU". Select the appropriate menu based upon which source (cable

or antenna) is being used.

Refer to pages 15 and 16 for further information on the "CHANNEL SETTING MENU" as well as for information on how to use the "AUTO

PROGRAM" function to program available channels.

Monitor rear panel

Antenna

InsIns

Ins

llatllat

llat

ion Insion Ins

ion Ins

tructruc

truc

ionsions

ions continued

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 40 41

Comentarios a estos manuales

Sin comentarios

Nec MultiSync LCD2335WXM Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Televisores Nec MultiSync LCD2335WXM