NEC Express5800/R120d-2E SR Guía de usuario descargar pdf (Pagina 10)

Command Parameter

Description

[-y]

Creates the Logical Drive immediately without displaying the message of

confirming that the Logical Drive may be created.

[Description]

Creates a Logical Drive with advanced parameter settings.

The raidcmd create a Logical Drive and terminates after Initialize is started. You can check the progress and

result of the Initialize by using "

oplist" and "property" commands.

RAID 0、RAID 1、RAID 5、RAID 6、RAID 10、RAID 50

RAID Levels allowed to be created

Physical Devices with [Status] of [Ready]

Available Physical Devices

Physical Devices not used at all

Disk Array has empty area at the end. The RAID Level of the Logical Drive to be created must be the same as

that of the Logical Drive existing on the same Disk Array.

Available Disk Array

Creates a single Disk Array and a single Logical Drive with the specified Physical Devices if the Disk Array is

created newly.

Configuration of Disk Array and Logical Drive to be created

For the RAID Level of RAID 10 or RAID 50, use the entire areas of Physical Devices to create a Logical Drive.

You cannot specify the capacities of the Physical Devices.

Capacity of Logical Drive with RAID Level of RAID 10 or RAID 50

[Condition]

This command can be executed only in the Advanced Mode.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Sin comentarios

NEC Express5800/R120d-2E SR Guía de usuario Pagina 10